User Guide

20
Via Ethernet
» Program monitoring account
Enter + 15 + PP + Enter, where PP = partition from 01 to 16. After the command: type the 4-digit monitoring account
number (0 to 9 or the letters B, C, D, E and F) and press the Enter key to conrm. If the center is not partitioned, use the
partition as 01.
» Program the report mode
Enter + 17 + AAA + Enter.
AAA = indicates in which mode the alarm center will operate, where 000: disabled, 400: regular IP and 600: dual IP.
» Program communication priority
Enter + 19 + 0 + Enter.
» Program destination IP
Enter + 801 + I + Enter, where I = Destination IP 1 or 2.
After the command type the IP number of the monitoring company (example: 192.168.001.100) and press the
Enter key
to conrm.
» Program IP network communication port
Port 1 = Enter + 802 + 1 + 4-digit port number + Enter.
Port 2 = Enter + 802 + 2 + 4-digit port number + Enter
» Program the destination domain name (DNS)
If you don’t want to use DNS, skip to the next command, otherwise type:
Enter + 803 + D + Enter, D = 1 or 2 (DNS 1 or DNS 2).
After the command type the DNS domain name and press the Enter key to conrm.
» Program IP monitoring options
Enter + 830 + Enter.
After the command, using the keys on the keyboard, enable the desired option from 1 to 4, where:
» 1 = enables the sending of events to the monitoring company 1.
» 2 = enables the sending of events to the monitoring company 2.
» 3 = Enables the domain name (DNS) of the monitoring company. 1.
» 4 = Enables the domain name (DNS) of the monitoring company. 2 and press the
Enter key to conrm.
» Program DHCP
If you do not have a DHCP server or do not want to use this option, proceed to the next step, otherwise, type the next
command and also the following commands.
Enter + 831 + Enter.
After the command, with the keyboard keys, enable option 1 (dial 1) and press the Enter key to conrm.
» Center IP address
Enter + 8120 + Enter.
After the command, enter the IP address of the center.
Note: you will only be able to edit/enter the address manually if the DHCP function is disabled, otherwise, only the IP
address of the center will be displayed.
» Program the netmask
Enter + 8130 + Enter.
After the command, type the netmask number and press the Enter key to conrm.
» Program the gateway
Enter + 8140 + Enter.
After the command, type the Gateway and press the Enter key to conrm.