User Guide

14
3.2. Ethernet/GPRS connection
» Ethernet: An RJ45 type cable must be installed in the center with the Ethernet signal coming from a router, switch or
directly from the signal received at the installation site. Check with the Internet provider whether the port used allows
external access.
» GPRS: with the GPRS connection enabled in the alarm center, the reporting of events and connections will use this
channel, and for this purpose the XG 2G or XG 3G module must be implemented together with the center and chips
with access to a data packet must be installed. To communicate via GPRS, the chip (SIM card) must be enabled for a
packet data plan. It is not necessary to enable voice service. Consult the operator to acquire the most suitable plan for
the information trafc of the alarm center.
In order to establish the GPRS connection with the alarm center, the following congurations must be
made.
» Enable chips
Enter + 832 + Enter.
» After the command, use the keyboard keys to enable options 1 (chip 1) and 2 (chip 2).
Program login
Enter + 822 + O + Enter , where O = 1 or 2 (Operator 1 or Operator 2)
After the command, type the user name (depending on the operator used) and then press the
Enter key to conrm.
» Program password
Enter + 823 + O + Enter, where O = 1 or 2 (Operator 1 or Operator 2)
After the command, type the password (depending on the operator used) and then press the
Enter key to conrm.
» Program APN
Enter + 824 + O + Enter, where O = 1 or 2 (Operator 1 or Operator 2)
After the command, type the APN (depending on the operator used) and then press the
Enter key to conrm.
Program the PIN (Personal Identication Number)
If you want to use the PIN, perform the command in sequence, otherwise go to the next command.
If the PIN is wrong, the chip will be blocked.
Enter + 825 + O + PIN number with 4 digits + where O = 1 or 2 (Operator 1 or Operator 2))
After selecting the type of connection to be used, it is necessary to carry out the following steps to verify/
congure some points of the connection, such as verifying the IP address that the center is operating
from.
IP address of the center
Enter + 8120 + Enter.
The IP address of the center will be displayed if DHCP is enabled, if DHCP is disabled you can manually enter the IP
address of the center.
» Program DHCP
If you do not have a DHCP server or do not want to use this option, proceed to the next step, otherwise, type the next
command and the following ones as well.
Enter + 831 + Enter.
After the command, using the keys on the keyboard, enable option 1 (dial 1) and press the Enter key to conrm. To
disable, leave option 1 unchecked.
Program the network mask
Enter + 8130 + Enter.
After the command, type the netmask number and press the Enter key to conrm.
Program the gateway
Enter + 8140 + Enter.
After the command, type the network gateway number and press the Enter key to conrm.