User Guide
11
» Restoring the digital tamper of the IVP 8000 EX sensor
Enter + 543 + ZZ+ Enter.
ZZ= 2-digit zone number.
» Display of sensors rmware
Enter + 641 + ZZ + Enter.
ZZ = 2-digit zone number.
Note:
function is available for devices with version 2.0.0.0 and higher. For devices with a version lower than 2.0.0.0,
0.0.0.0 will be displayed.
Wireless sirens
» Register wireless sirens
Enter + 621 + NS + Enter + Actuate the siren by pressing the synchronization key.
NS = siren number from 01 to 16.
» Delete wireless sirens
Enter + 721 + NS + Enter.
NS = siren number from 01 to 16.
Note:
it is not possible to delete the position of the integrated siren.
» Partitioning of wireless sirens
Enter + 222 + NS + PP + Enter.
NS = siren number from 01 to 16.
PP = partition from 00 to 16 (00 = common address for all zones and 01 to 16 the individual partitions of the center).
» Enable/disable siren beep on system activation/deactivation
Enter + 510 + Enter + Key 3 + Enter.
» Enable/disable siren beep per partition
Enter + 224 + GP + Enter.
GP = group of partitions, with partitions 01 to 10 in group 0 and partitions 11 to 16 in group 1.
» Enable/disable integrated siren
Enter + 541 + Enter
After the command, use the 1 key on the keyboard to enable or disable the function and press the
Enter
key to conrm.
» Change siren time
Enter + 41 + TS + Enter.
TS = siren time from 01 to 99.
Note:
factory default 5 minutes, and if 00 is set in the command, an error beep will be emitted.
» Register RF range amplier (REP 8000 repeater)
Enter + 622 + NA + Enter + Actuate the amplier by pressing the synchronization key.
NA = amplier number from 01 to 04.
» Delete RF Range Amplier (REP 8000 Repeater)
Enter + 722 + NA + Enter
NA = amplier number from 01 to 04.