User's Manual

Chapter 3 – Setting up the Gateway with a Network

2002 Intel Corporation

Step-by-step To connect the gateway to a hub or switch:

1 Connect one end of the Ethernet cable (included with

the gateway) to any one of the four Ethernet ports on

the gateway.

2 Connect the other end to the Ethernet cable to an

available port on your hub or switch.

3 Connect the power cable to the power supply.

4 Connect the power cable to an electrical wall outlet.

5 Connect the power supply cable to the Power port on

the gateway.

Note If you are using the gateway as a DHCP server,

make sure the computers on your network are

configured to be DHCP clients. Refer to Chapter

5 for information.

Power

Eth

ernet

DSL

set