User's Manual

Chapter 3 – Setting up the Gateway with a Network
Copyright
©
2002 Intel Corporation
20
Connecting the gateway to an Ethernet hub or switch
Once you have established a connection between the
gateway and a single computer with an Ethernet adapter,
you can then connect additional computers to the wired
network.
Related topics •See Connecting the gateway to a wireless network
on page 22.
•See Using the Wireless Network Configuration
Wizard on page 25.
•See Configuring the gateway’s firewall on page 41.
•See Using port forwarding on page 49.
Note Do not attempt to connect multiple computers to
form a network until you have configured the
gateway to work with a single computer. Refer to
your Installation Guide for instructions on
configuring the gateway to do this.