Product Guide

Updating the BIOS
51
1. Observe the precautions in "Before You Begin" on page 25.
2. Connect the 12-V processor core voltage power supply cable to the 2 x 4 pin
connector.
3. Connect the main power supply cable to the 2 x 12 pin connector.
Setting the BIOS Configuration Jumper
NOTE
Before moving the jumper, you must always turn off the power and unplug the power
cord from the computer. Moving the jumper with the power on may result in unreliable
computer operation.
Figure 27 shows the location of the Intel
®
Workstation Board WX58BP’s BIOS
configuration jumper block.
Figure 27. Location of the BIOS Configuration Jumper Block
The three-pin BIOS jumper block allows you to complete all board configurations in the
BIOS Setup program. Table 12 shows the jumper settings for the BIOS Setup program
modes.