Operating Manual

Troubleshooting and tips
User and/or supervisor SmartCard lost
Cause
Troubleshooting
User and/or supervisor SmartCard lost Ź If you have lost your user SmartCard, you
can continue to work with the supervisor
SmartCard.
Ź If you have lost the supervisor SmartCard,
you can also continue working, but yo u no
longer have all rights and cannot initialize
another supervisor SmartCard.
Acoustic warning
Acou stic war ning sErrors
Cause
Troubleshooting
A beep sounds every few seconds.
The battery is almost dead.
Ź Charge the battery.
Error messages on the screen
Errormess ageso
nthes creen
Errors
This section describes the error messages generated by the BIOS Setup. Error messages displayed
by the operating system or programs a re describe d in the documentation for these programs.
If the error message appears repeatedly despite troubleshooting measures,
contact the place of purchase or our custom er service center.
Error message/cause Troubleshooting
CMOS Battery Bad
If the error message occurs repeatedly, the
back-up battery in the note book is dead.
Ź Contact your sales outlet or our customer
service center.
System CMOS checksum bad - Default configuration
used
The system con¿guration information is
incorrect.
Ź Switch the note book off.
Ź Switch the notebook on.
Ź Press the function key
F2
to access the
BIOS Setup.
Ź In the BIOS Setup, select the Exit menu.
Ź Select the entry Load Setup Defaults.
Ź Select OK and press the Enter key.
Extended memory failed at offset: xxxx Failing Bits:
zzzz zzzz
When testing the extended memory. an error
has resulted at the address xxxx.
Ź Check
whether the additional memory
modul
e has been inserted correctly.
Failure Fixed Disk n
The settings of the hard disk drive are incorrect.
Ź Sta
rt the BIOS Setup (Primary Master
sub
menu) and select the correct settings.
Fujitsu 95