Service Guide

Hardware Installations and Upgrades
62 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
Removing Third 8x2.5” Hot-swap Hard Disk Drive Cage
Assembly
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
4. Remove the front bezel if it is installed. For instructions, see “Removing the Front Bezel (Pedestal Only)”.
5. Disconnect the power and data cables to the backplane.
6. Use screwdriver to release the hot-swap hard drive cage (see letter C) from the chassis and remove the
hot-swap hard drive cage (see letter D).
Figure 77. Removing the top 8x2.5” Hot-swap HDD Cage Assembly
Installing Top 8x2.5” Hot-swap Hard Disk Drive Cage
Assembly
CAUTION
It is critical that you connect the SAS/SATA data cables correctly from the SAS/SATA backplane to
your server board or RAID controller card. Failure to do so may result in data loss.