Service Guide

Hardware Installations and Upgrades
Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide 41
6. Get the slides from the chassis side (see letter B). Attach slides to the DVD or CD-ROM drive by
pressing the slides firmly into the side dimples on the DVD or CD-ROM drives (see letter C). Insert
the drive/slide assembly into the device bay until the slides lock into place (see letter D).
Figure 51. Installing DVD or CD-ROM Drive
Removing a DVD or CD-ROM Drive
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
4. Remove the front bezel if it is installed. For instructions, see “Removing the Front Bezel”.
5. Disconnect the power and data cables to the DVD/CD-ROM drive.
6. Press on the slide release latches (see letter A in the following figure) and pull the DVD/CD-ROM
drive/slide assembly from the chassis (see letter B in the following figure). Remove the slides from
the DVD or CD-ROM drive (see letter C).
Figure 52. Removing DVD or CD-ROM Drive