Service Guide

Hardware Installations and Upgrades
30 Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide
Installing the Airduct
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
4. Install the airduct by matching the alignment tabs on airduct and the alignment holes on chassis bracket.
Figure 34. Installing the Airduct
Removing and Installing Processor
The heatsink has Thermal Interface Material (TIM) on the underside of it. Use caution so that you
do not damage the thermal interface material. Use gloves to avoid sharp edges.
Removing Processor Heatsink(s)
The heatsink is attached to the server board/processor socket with captive fasteners. Using a #2
Phillips* screwdriver, loosen the four screws located on the heatsink corners in a diagonal manner
using the following procedure:
1. Using a #2 Phillips* screwdriver, start with screw 1 and loosen it by giving it two rotations and stop (see
letter A). (IMPORTANT: Do not fully loosen.)
2. Proceed to screw 2 and loosen it by giving it two rotations and stop (see letter B). Similarly, loosen screws
3 and 4. Repeat steps A and B by giving each screw two rotations each time until all screws are loosened.