Service Guide

Hardware Installations and Upgrades
Intel
®
Server System P4000IP and Intel
®
Workstation System P4000CR Service Guide 91
9. Slide the front panel out from the front of the chassis to the place (see letter C) so that you can reach
the front panel cable and instrustion cable connectors at the rear of the front panel. Then disconnect
the front panel cable and intrusion switch cable from the front panel board (see letter D).
Figure 126. Disconnecting the Cables from Front Panel Board
10. Slide the front panel tray out.
Installing the Front Panel Tray
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
4. Remove the front bezel if it is installed. For instructions, see “Removing the Front Bezel”.
5. Remove the air duct if it is installed.