Datasheet

Intel® Solid-State Drive DC S3610 Series
The following conclusions can be made for this example case:
The workload took 500 minutes to complete with 80% reads and 20% writes. A total of 1,007 GB of
data was written to the device, which increased the media wear in the drive by 0.016%. At this point
in time, this workload is causing a wear rate of 0.016% for every 500 minutes, or 0.00192%/hour.
5.4.3 SMART Logs
The Intel SSD DC S3610 Series implements the following Log Addresses: 00h, 02h, 03h, 06h, and 07h.
The DC S3610 Series implements host vendor specific logs (addresses 80h-9Fh) as read and write
scratchpads, where the default value is zero (0). Intel SSD DC S3610 does not write any specific values to
these logs unless directed by the host through the appropriate commands.
The DC S3610 Series also implements a device vendor specific log at address A9h as a read-only log
area with a default value of zero (0). Besides that, the DC S3610 Series also implements log address B8h
(if the drive is in disable logical mode, log address B8h will have the word error code for *BAD_CTX).
Finally the DC S3610 Series also implements log at addresses B9h and BAh (both of them are Intel®
error logs, and read only for customers).
5.5 Device Statistics
In addition to the SMART attribute structure, statistics pertaining to the operation and health of the Intel
SSD DC S3610 Series can be reported to the host on request through the Device Statistics log as defined
in the ATA specification.
The Device Statistics log is a read-only GPL/SMART log located at read log address 0x04 and is
accessible using READ LOG EXT, READ LOG DMA EXT or SMART READ LOG commands.
Table 20 lists the Device Statistics supported by the Intel SSD DC S3610 Series.
Table 21: Serial ATA Power Pin Definitions—2.5-inch Form Factors
Page Offset Description
Equivalent SMART
attribute (if applicable)
0x00
--
List of Supported Pages
--
0x01 – General Statistics
0x08
Power Cycle Count
0Ch
0x10
Power-On Hours
09h
0x18
Logical Sectors Written
E1h
0x20
Num Write Commands – incremented by
one for every host write
--
0x28
Logical Sectors Read
F2h
0x30
Num Read Commands – incremented by one
for every host read
--
0x04 – General Error Statistics
0x08 Num Reported Uncorrectable Errors BBh
0x10
Num Resets Between Command Acceptance
and Completion
--
0x05 – Temperature Statistics
0x00 Device Statistics Information Header --
0x08 Current Temperature --
0x10 Average Short Term Temperature --
0x18 Average Long Term Temperature --
0x20 Highest Temperature --
0x28 Lowest Temperature --
0x30 Highest Average Short Term Temperature --
March 2015 Product Specification
331342-003US 25