Datasheet

ManualsBrandsIntel Manualscomputers & electronicsSSDSA2CW080G301

Order Number: 325152-002US

September 2011

Intel

Solid-State Drive 320 Series

Product Specification

1. Performance values vary by capacity.

2. 4 KB = 4,096 bytes.

3. Idle power measured with Device Initiated Power Management (DIPM) enabled.



Form Factors: 1.8-inch and 2.5-inch

 Capacity:

— 80/160/300 GB (1.8-inch)

— 40/80/120/160/300/600 GB (2.5-inch)

 Components:

—Intel

25nm NAND Flash Memory

— Multi-Level Cell (MLC)

 Bandwidth Performance

(Iometer* Queue Depth 32)

— Sustained Sequential Read: Up to 270 MB/s

— Sustained Sequential Write: Up to 220 MB/s

 Read and Write IOPS

(Iometer Queue Depth 32)

—Random 4 KB

Reads: Up to 39,500 IOPS

— Random 4 KB Writes: Up to 23,000 IOPS

 Latency (average sequential)

— Read: 75 µs (TYP)

— Write: 90 µs (TYP)

 AES 128-bit Encryption

 Compatibility

—Intel

SSD Toolbox with Intel

SSD Optimizer

—Intel

Data Migration Software

—Intel

Rapid Storage Technology

—Intel

6 Series Express Chipsets

(with SATA 6Gb/s)

—SATA Revision 2.6

—ATA8-ACS

— SSD-enhanced SMART ATA feature set

— Native Command Queuing (NCQ)

command set

— Data Set Management Command

Trim attribute

 Power Management

— 3.3 V (1.8-inch form factor) or

5 V (2.5-inch form factor) SATA Supply Rail

— SATA Interface Power Management

— OS-aware hot plug/removal

— Enhanced power-loss data protection

 Power

— Active (MobileMark* 2007 Workload):

150 mW (TYP)

—Idle

: 100 mW (TYP)

 Temperature

—Operating: 0

C to 70

— Non-Operating: -55

C to 95

 Reliability

— Uncorrectable Bit Error Rate (UBER):

1 sector per 10

bits read

— Mean Time Between Failures (MTBF):

1,200,000 hours

 Shock (operating and non-operating):

1,500 G/0.5 msec

 Vibration

— Operating: 2.17 G

RMS

(5-700 Hz)

— Non-operating: 3.13 G

RMS

(5-800 Hz)

 Weight

— 1.8-inch form factor: Up to 49 grams

— 2.5-inch 7mm form factor: Up to 82 grams

— 2.5-inch 9.5mm form factor: Up to 88 grams

 Certifications and Declarations:

—UL*

—CE*

—C-Tick*

—BSMI*

—KCC*

—Microsoft* WHQL

— VCCI*

—SATA-IO*

 Product Ecological Compliance

—RoHS*

Summary of content (28 pages)

PAGE 1
Intel® Solid-State Drive 320 Series Product Specification          Form Factors: 1.8-inch and 2.5-inch Capacity: — 80/160/300 GB (1.8-inch) — 40/80/120/160/300/600 GB (2.
PAGE 2
Ordering Information L Contact your local Intel sales representative for ordering information. INFORMATION IN THIS DOCUMENT IS PROVIDED IN CONNECTION WITH INTEL PRODUCTS. NO LICENSE, EXPRESS OR IMPLIED, BY ESTOPPEL OR OTHERWISE, TO ANY INTELLECTUAL PROPERTY RIGHTS IS GRANTED BY THIS DOCUMENT.
PAGE 3
Intel® Solid-State Drive 320 Series Contents 1.0 Overview ................................................................................................................... 5 2.0 Product Specifications ............................................................................................... 6 2.1 Capacity ............................................................................................................ 6 2.2 Performance ...................................................................
PAGE 4
Intel® Solid-State Drive 320 Series Intel® Solid-State Drive 320 Series Product Specification 4 September 2011 Order Number: 325152-002US
PAGE 5
Intel® Solid-State Drive 320 Series 1.0 Overview This document describes the specifications and capabilities of the Intel® Solid-State Drive 320 Series (Intel® SSD 320 Series). The Intel SSD 320 Series delivers leading performance for Serial Advanced Technology Attachment (SATA)-based computers in capacities up to 600 GB.
PAGE 6
Intel® Solid-State Drive 320 Series 2.0 Product Specifications 2.1 Capacity Table 1. User Addressable Sectors Unformatted Capacity (Total User Addressable Sectors in LBA Mode) Intel SSD 320 Series 40 GB 78,165,360 80 GB 156,301,488 120 GB 234,441,648 160 GB 312,581,808 300 GB 586,072,368 600 GB 1,172,123,568 Notes: 1 GB = 1,000,000,000 bytes; 1 sector = 512 bytes. LBA count shown represents total user storage capacity and will remain the same throughout the life of the drive.
PAGE 7
Intel® Solid-State Drive 320 Series 2.3 Electrical Characteristics Table 5. Operating Voltage and Power Consumption Electrical Characteristics Value Operating Voltage for 5 V (+/- 5%) Min Max 4.75 V 5.25 V Power Consumption (Typical) Active1 Idle2 150 mW 100 mW Notes: 1. Active power measured during execution of MobileMark* 2007 with Device Initiated Power Management (DIPM) enabled. 2. Idle power defined as SSD at idle with DIPM enabled. 2.4 Environmental Conditions Table 6.
PAGE 8
Intel® Solid-State Drive 320 Series 2.5 Product Regulatory Compliance The Intel SSD 320 Series meets or exceeds the regulatory or certification requirements in Table 7. Table 7. Product Regulatory Compliance Specifications Description Region for which conformity declared European Union Low Voltage Directive (LVD) 2006/95/EC EN 60950-1 2nd edition for Information Technology Equipment Safety - Part 1: General Requirements European Union UL/CSA 60950-1, Second Edition CAN/CSA-C22.2 No.
PAGE 9
Intel® Solid-State Drive 320 Series 2.6 Reliability The Intel SSD 320 Series meets or exceeds SSD endurance and data retention requirements as specified in the JESD218 specification. Reliability specifications are listed in Table 8. Table 8. Reliability Specifications Parameter Value Uncorrectable Bit Error Rate (UBER) 1 sector in 1016 bits read, max Uncorrectable bit error rate will not exceed one sector in the specified number of bits read.
PAGE 10
Intel® Solid-State Drive 320 Series 3.0 Mechanical Information 3.1 1.8-inch Form Factor Figure 1 shows the physical package information for the 1.8-inch Intel SSD 320 Series. All dimensions are in millimeters. Figure 1. Dimensions for 1.8-inch Form Factor 1,350 2,500 1,650 78.50 0.60 3.30 0.35 DETAIL A SCALE 5 : 1 54.00 A 5.00 0.
PAGE 11
Intel® Solid-State Drive 320 Series 3.2 2.5-inch Form Factors Figure 2 shows the physical package information for the 7mm height 2.5-inch Intel SSD 320 Series. All dimensions are in millimeters. Figure 2. Dimensions for 7mm 2.
PAGE 12
Intel® Solid-State Drive 320 Series Figure 3 shows the physical package information for the 9.5mm height 2.5-inch Intel SSD 320 Series. All dimensions are in millimeters. Figure 3. Dimensions for 9.5mm 2.
PAGE 13
Intel® Solid-State Drive 320 Series 4.0 Pin and Signal Descriptions 4.1 Pin Locations 4.1.1 1.8-inch Form Factor Pin Locations Figure 4. Layout of Signal and Power Segment Pins Signal Segment S1 Power Segment P1 4.1.2 2.5-inch Form Factor Pin Locations Figure 5. Layout of Signal and Power Segment Pins Signal Segment S1 Note: Power Segment P1 2.5-inch connector supports in-built latching capability.
PAGE 14
Intel® Solid-State Drive 320 Series 4.2 Signal Descriptions 4.2.1 Connector Pin Signal Definitions Table 9. Serial ATA Connector Pin Signal Definitions — 1.8-inch and 2.5-inch Form Factors Note: Pin Function S1 Ground S2 A+ S3 A- S4 Ground S5 B- S6 B+ S7 Ground Definition 1st mate Differential signal pair A 1st mate Differential signal pair B 1st mate Key and spacing separate signal and power segments. 4.2.2 Power Pin Signal Definitions Table 10.
PAGE 15
Intel® Solid-State Drive 320 Series Table 11. Serial ATA Power Pin Definitions — 2.5-inch Form Factor Pin1 Function Definition 2 Not connected (3.3 V Power) P22 Not connected (3.3 V Power) 2 Not connected (3.
PAGE 16
Intel® Solid-State Drive 320 Series 5.0 Supported Command Sets The Intel SSD 320 Series supports all the mandatory ATA (Advanced Technology Attachment) commands defined in the ATA8-ACS specification described in this section. 5.
PAGE 17
Intel® Solid-State Drive 320 Series 5.3 Security Mode Feature Set The Intel SSD 320 Series supports the Security Mode command set, which consists of: • SECURITY SET PASSWORD • SECURITY UNLOCK • SECURITY ERASE PREPARE • SECURITY ERASE UNIT • SECURITY FREEZE LOCK • SECURITY DISABLE PASSWORD 5.
PAGE 18
Intel® Solid-State Drive 320 Series 5.4.1 SMART Attributes Table 12 lists the SMART attributes supported by the Intel SSD 320 Series and the corresponding status flags and threshold settings. Table 12. ID SMART Attributes Attribute Status Flags SP EC ER PE OC PW Threshold 03h Spin Up Time Reports a fixed value of zero (0). 1 0 0 0 0 0 0 (none) 04h Start/Stop Count Reports a fixed value of zero (0).
PAGE 19
Intel® Solid-State Drive 320 Series Table 12. SMART Attributes (Continued) ID Attribute Status Flags SP EC ER PE OC PW Threshold C7h1 CRC Error Count The total number of encountered SATA interface cyclic redundancy check (CRC) errors. 1 1 0 0 1 0 0 (none) E1h Host Writes The raw value of this attribute reports the total number of sectors written by the host system. The raw value is increased by 1 for every 65,536 sectors (32MB) written by the host.
PAGE 20
Intel® Solid-State Drive 320 Series 5.4.2 SMART Logs The Intel SSD 320 Series implements the following Log Addresses: 00h, 02h, 03h, 06h, and 07h. The Intel SSD 320 Series implements host vendor specific logs (addresses 80h-9Fh) as read and write scratchpads, where the default value is zero (0). Intel SSD 320 Series does not write any specific values to these logs unless directed by the host through the appropriate commands.
PAGE 21
Intel® Solid-State Drive 320 Series 5.
PAGE 22
Intel® Solid-State Drive 320 Series 5.9 48-Bit Address Command Set The Intel SSD 320 Series supports the 48-bit Address command set, which consists of: • FLUSH CACHE EXT • READ DMA EXT • READ NATIVE MAX ADDRESS • READ NATIVE MAX ADDRESS EXT • READ SECTOR(S) EXT • READ VERIFY SECTOR(S) EXT • SET MAX ADDRESS EXT • WRITE DMA EXT • WRITE MULTIPLE EXT • WRITE SECTOR(S) EXT 5.
PAGE 23
Intel® Solid-State Drive 320 Series 6.0 Certifications and Declarations Table 15 describes the Device Certifications supported by the Intel SSD 320 Series. Table 15. Device Certifications and Declarations Certification Description CE Compliant Indicates conformity with the essential health and safety requirements described in European Directives Low Voltage Directive and EMC Directive. UL Certified Underwriters Laboratories, Inc. Component Recognition UL60950-1.
PAGE 24
Intel® Solid-State Drive 320 Series 8.0 Terms and Acronyms Table 17 defines the terms and acronyms used in this document. Table 17.
PAGE 25
Intel® Solid-State Drive 320 Series 9.0 Revision History Date Revision Description September 2011 002 Updated Figure 2, “Dimensions for 7mm 2.5-inch Form Factor” . Updated Figure 3, “Dimensions for 9.5mm 2.5-inch Form Factor” . Updated SMART attributes ABh and ACh. Added SMART attributes B7h, C7h, BBh, E2h, E3h, and E4h. Changed offset 0x18 in 0x06 - Transport Statistics in Table 14 on page 20 from “Num Interface CRC Errors” to “CRC Error Count”. Misc. documentation changes.
PAGE 26
Intel® Solid-State Drive 320 Series Appendix A IDENTIFY DEVICE Command Data Table 18 details the sector data returned after issuing an IDENTIFY DEVICE command. Table 18.
PAGE 27
Intel® Solid-State Drive 320 Series Table 18.
PAGE 28
Intel® Solid-State Drive 320 Series Table 18.