Datasheet

Intel® Server System SR1640TH TPS Functional Architecture
Revision 1.0 51
Intel order number: E94847-001
2.6.6 Loading BIOS Defaults
Different mechanisms exist for resetting the system configuration to the default values.
When a request to reset the system configuration is detected, the BIOS loads the default
system configuration values during the next POST. You can send the request to reset the
system to the defaults in the following ways:
Pressing <F9> from within the BIOS Setup utility.
Moving the clear system configuration jumper.
IPMI command (set System Boot options command)
Int15 AX=DA209
Choosing Load User Defaults from the Exit page of the BIOS Setup loads user set defaults
instead of the BIOS factory defaults.
The recommended steps to load the BIOS defaults are:
1. Power down the system (Do not remove AC power).
2. Move the Clear CMOS jumper from pins 1-2 to pins 2-3.
3. Move the Clear CMOS jumper from pins 2-3 to pins 1-2.
4. Power up the system.
2.7 Connector/Header Locations and Pin-outs
2.7.1 General Purpose Connectors
The following section provides detailed information regarding all connectors, headers, and
jumpers on the server board. It lists all connector types available on the board and the
corresponding reference designators printed on the silkscreen.
Table 36. Board Connector Matrix
Name Ref on MB
Connector Type
Pin Count
RMM3 Lite-V internal header J1G1, J7E1 Header 8
Front USB connector J7K1 Connector 24
Front Panel header J8K1 Header 34
SAS 4i connector J9J2 Connector 32
IPMB header J6K1 header 4
System Power connector J9H1 connector 44
Board Identity LED connector J3B1 connector 3
FAN connector J4K1, J6K2, J4K2 connector 8
Power connector to HDD J7K2 connector 6