Datasheet

Appendix D: POST Code Errors Intel® Server System SR1640TH TPS
Revision 1.0
Intel order number: E94847-001
105
Error Code Error Message Response
92C8 Serial Port component encountered an output error. No Pause
94C6 LPC component encountered a controller error. No Pause
94C9 LPC component encountered a resource conflict error. Pause
9506 ATA/ATPI component encountered a controller error. No Pause
95A6 PCI component encountered a controller error. No Pause
95A7 PCI component encountered a read error. No Pause
95A8 PCI component encountered a write error. No Pause
9609 Unspecified software component encountered a start error. No Pause
9641 PEI Core component encountered a load error. No Pause
9667 PEI module component encountered an illegal software state error. Halt
9687 DXE core component encountered an illegal software state error. Halt
96A7 DXE boot services driver component encountered an illegal software state error. Halt
96AB DXE boot services driver component encountered invalid configuration. No Pause
96E7 SMM driver component encountered an illegal software state error. Halt
0xA022 Processor component encountered a mismatch error. Pause
0xA027 Processor component encountered a low voltage error. No Pause
0xA028 Processor component encountered a high voltage error. No Pause
0xA421 PCI component encountered a SERR error. Halt
0xA500 ATA/ATPI ATA bus SMART not supported. No Pause
0xA501 ATA/ATPI ATA SMART is disabled. No Pause
0xA5A0 PCI Express* component encountered a PERR error. No Pause
0xA5A1 PCI Express* component encountered a SERR error. Halt
0xA5A4 PCI Express* IBIST error. Pause
0xA6A0
DXE boot services driver Not enough memory available to shadow a legacy
option ROM.
No Pause
POST Error Beep Codes
The following table lists POST error beep codes. Prior to system video initialization, the
BIOS uses these beep codes to inform users on error conditions. The beep code is followed
by a user-visible code on POST Progress LEDs.
Table 84. POST Error Beep Codes
Beeps Error Message POST Progress Code Description
3 Memory error Multiple System halted because a fatal error related to the memory
was detected.