Specifications

66 Intel
®
Server System SR1630GPRX/SR1630HGPRX Service Guide
5. Remove the screw at the rear of the riser assembly. See letter “A” in Figure 52.
Save this screw. You will use it later.
6. Pull the add-in card from the socket in the riser assembly. You may need to wriggle
the card from front to back to remove it, but use caution so you do not twist or bend
the card. See letter “B” in Figure 52.
7. Install a filler panel over the opening at the rear of the riser assembly. See letter “C”
in Figure 52.
8. Re-install the screw you removed in Step 5. See letter “A” in Figure 52.
Figure 52. Removing a Full Height Add-In Card
Note: Make sure that all empty add-in card slots have filler panels installed.
9. Install the PCIe* Riser assembly into the server system. For instructions, see
“Installing the PCIe* Riser Assembly”.
10. Install the processor air duct. For instructions, see “Installing the Processor Air
Duct”.
11. Install the server system cover. For instructions, see “Installing the Server System
Cover”.
12. Plug all peripheral devices and the AC power cable into the server.
Riser Connector
Riser Card
Add-in Card
AF003372
A
C
B