Specifications

Intel
®
Server System SR1630GPRX/SR1630HGPRX Service Guide 65
5. Remove the screw at the rear of the riser assembly. See letter “A” in Figure 51.
Save this screw. You will reinstall it later.
6. If a filler panel is installed over the opening at the rear of the riser assembly, lift it
from the riser assembly. See letter “B” in Figure 51. Save the filler panel in case
you later need to remove the add-in card.
7. Insert the add-in card into the socket in the riser assembly. Push the add-in card into
place firmly until it seats in the riser card connector, but use caution so you do not
twist or bend the card. See letter “C” in Figure 51.
8. Re-install the screw you removed in Step 5. See letter “A” in Figure 51.
Figure 51. Installing an Add-In Card
9. Install the PCIe* Riser assembly into the server system. For instructions, see
“Installing the PCIe* Riser Assembly”.
10. Install the server system cover. For instructions, see “Installing the Server System
Cover”.
11. Plug all peripheral devices and the AC power cable into the server.
Removing a PCI Add-in Card
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover”.
4. Remove the PCIe* Riser assembly. For instructions, see “Removing the PCIe*
Riser Assembly”.
Riser Connector
Riser Card
Add-in Card
AF003371
A
B
C