Specifications

56 Intel
®
Server System SR1630GPRX/SR1630HGPRX Service Guide
10. Install the server system cover. For instructions, see “Installing the Server System
Cover”.
11. Plug all peripheral devices and the AC power cable into the server.
Removing a Slimline Optical Drive
1. Observe the safety and ESD precautions at the beginning of this book. See “Safety
Information”.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the server system cover. For instructions, see “Removing the Server
System Cover”.
4. Disconnect the optical drive power and data cables. See letters “A” and “B” in
Figure 41.
5. Remove the screw that holds the optical drive bracket to the server chassis. See
letter “C” in Figure 41. Save this screw. You will reinstall it later.
6. Slide the optical drive out through the front of the system. See letter “D” in
Figure 41.
Figure 41. Removing the Optical Drive from the Server System
7. Remove the four screws that hold the optical drive to the brackets as shown in
Figure 42. Save these screws for future use.
D
C
AF000670
B
A