Specifications

Intel

Server System SR1630GPRX/SR1630HGPRX Service Guide 53

9. With the black lever in the fully open position, slide the drive assembly into the

server system (see letter “A” in Figure 37). The green latch at the front of the drive

carrier must be to the right. Do not push on the black drive carrier lever until the

lever begins to close by itself.

10. When the black drive carrier lever begins to close by itself, push on it to lock the

drive assembly into place (see letter “B” in Figure 37).

Figure 37. Install Drive Assembly into the Server System (SR1630HGPRX)

11. Install the server system cover. For instructions, see “Installing the Server System

Cover”.

12. Plug all peripheral devices and the AC power cable into the server.

Removing a Hot-Swap SATA Drive (SR1630HGPRX)

1. Press in on the green latch at the front of the hard drive carrier.

2. Pull out on the black lever to slide the carrier from the server system.

3. Remove the four screws that attach the hard drive to the drive carrier. Lift the drive

from the carrier. Store the drive in an anti-static bag.

4. If you are not installing a new drive, place the plastic retention device into the drive

carrier, using the four screws you removed from the hard drive.

5. Insert the screws that held the drive in the carrier into the screw locations on the

carrier for future use.

6. With the black lever in the fully open position, slide the drive carrier into the server

system. The green latch must be to the right. Do not push on the black lever until

the lever begins to close by itself.

Note: For proper airflow, you must replace the hard drive carrier in the server system, even if no

hard drive is installed in it.

7. When the black lever begins to close by itself, push on it to lock the drive carrier

into place.

AF001585