Specifications

Intel
®
Server System SR1630GPRX/SR1630HGPRX Service Guide 47
14. HDD1 only: Route the power cable into the cable clip on the top of the hard drive
bracket. See Figure 32.
15. Connect the data cables to the drive(s).
— Letter “A”: If a drive is installed in the HDD1 carrier, connect the HDD1 data
cable from the SATA 1 connector on the server board (letter “F”) to the hard
drive (letter “C”). See Figure 32.
— Letter “B”: If a drive is installed in the HDD0 carrier, connect the HDD0 data
cable from the SATA 0 connector on the server board (letter “F”) to the hard
drive (letter “C”). See Figure 32.
Note: The data cables are factory routed underneath the fan module (see letter “E”). Use
caution to make sure you connect the correct cables between the server board and the
hard drives. The cables are labeled at each end.
16. Connect the power cables to the drive(s):
— Letter “A”: If a drive is installed in the HDD1 carrier, attach the connector on
the daisy chain power cable that is closest to the power supply to the HDD1
connector. See letter “D” in Figure 32.
— Letter “B”: If a drive is installed in the HDD0 carrier, attach the middle
connector on the daisy chain power cable to the HDD0 power connector. See
letter “D” in Figure 32.