Specifications

Intel® Server System SR1630BC Power Sub-System

Revision 1.3

Intel order number E44588-003

3.2.5 P6 – Slim-line SATA Optical Disk Drive Power Connector

Connector housing: 6-pin SATA Power

Contact: 15u plating minimum

Table 11. P6 – Slim-line SATA Optical Disk Drive Power Connector Pin-out

Pin Signal 22 AWG Color

1 Reserved N.C.

2 +5 VDC Red

3 +5 VDC Red

4 Reserved N.C.

5 COM Black

6 COM Black

3.3 Efficiency

The following table provides the required minimum efficiency level at various loading conditions.

These are provided at three different load levels: 100%, 50%, and 20%. Output should be

loaded according to the proportional loading method defined by 80 Plus. Efficiency should be

tested per 80 plus requirement.

Table 12. Power Supply Efficiency

Loading 100% of Maximum 50% of Maximum 20% of Maximum

Minimum Efficiency 82% 85% 82%

3.4 AC Input Voltage Requirement

The power supply must operate within all specified limits over the following input voltage range,

shown in the following table. Harmonic distortion of up to 10% THD must not cause the power

supply to go out of specified limits. The power supply shall power off if the AC input is less than

75 VAC +/- 5 VAC range. The power supply should start up if the AC input is greater than 85

VAC +/- 4 VAC. Application of an input voltage below 85 VAC shall not cause damage to the

power supply, including a fuse blow.

Table 13. AC Input Rating

Parameter Minimum Rated Maximum Start up VAC Power Off VAC

Voltage (110) 90 V

rms

100-127 V

rms

140 V

rms

85Vac +/-4Vac 75Vac +/-5Vac

Voltage (220) 180 V

rms

200-240 V

rms

264 V

rms

Frequency 47 Hz 63 Hz