Specifications

Intel® Server Board S3420GPRX TPS Design and Environmental Specifications
Revision 1.1
Intel order number E92065-001
105
The output voltages must rise from 10% to within regulation limits (T
vout_rise
) within 5 ms
to 70 ms, except for 5 VSB, in which case it is allowed to rise from 1.0 ms to 25 ms.
The +3.3 V, +5 V, and +12 V output voltages should start to rise approximately at the
same time.
All outputs must rise monotonically.
The +5 V output must be greater than the +3.3 V output during any point of the voltage
rise.
The +5 V output must never be greater than the +3.3 V output by more than 2.25 V.
Each output voltage should reach regulation within 50 ms (T
vout_on
) of each other when
the power supply is turned on.
Each output voltage should fall out of regulation within 400 msec (T
vout_off
) of each other
when the power supply is turned off.
Figure 43 and Figure 44 show the timing requirements for the power supply being turned on and
off via the AC input with PSON held low and the PSON signal with the AC input applied.
Table 75. Output Voltage Timing
Item Description Minimum Maximum Units
T
vout_rise
Output voltage rise time from each main output. 5.0
1
70
1
Msec
T
vout_on
All main outputs must be within regulation of each
other within this time.
50 Msec
T
vout_off
All main outputs must leave regulation within this
time.
700 Msec
Note:
1. The 5 VSB output voltage rise time should be from 1.0 ms to 25.0 ms.
Figure 43. Output Voltage Timing