Service Guide

Hot Swap Drive Cage Upgrade Install Instructions (optional)
Intel® Server Chassis SC5650-DP/WS/BRP/UP Service Guide 71
17. Make the backplane and server board/RAID controller card cable connections. Cable
instructions differ depending upon whether you are installing an SAS/SATA hot swap
drive cage. Refer to the documentation that came with your server board and/or RAID
controller card for instructions on connecting backplane cables to your server board or
RAID controller card.
Warning: It is critical that you connect the SAS/SATA data cables correctly from the
SAS/SATA backplane to your server board or RAID controller card.
Failure to do so may result in data loss.
Note: Connect the SES cable from the backplane to the RAID card (if one is
installed).
a. If you are installing a six-drive SAS/SATA hot swap drive cage:
Warning: It is critical that you connect the SAS/SATA data cables correctly from the
SAS/SATA backplane to your server board or RAID Controller card.
Failure to do so may result in data loss.
Note: The SAS/SATA cables are labeled to correspond with each drive. Make sure to
connect the cables correctly to avoid confusion later.