Service Guide

Hardware Installations and Upgrades

Intel® Server Chassis SC5650-DP/WS/BRP/UP Service Guide 33

11. Plug all peripheral devices and the AC power cable(s) into the server. Power up the

server.

Installing or Removing a DVD-ROM or CD-ROM Drive

Caution: CD-ROM and DVD-ROM drives are NOT hot-swappable. Before removing or replacing

the drive, you must first take the server out of service, turn off all peripheral devices

connected to the system, turn off the system by pressing the power button, and unplug the

AC power cord from the system or wall outlet.

Installing a DVD-ROM or CD-ROM Drive

1. Observe the safety and ESD precautions listed in Appendix A, “Safety Information”.

2. Power down the server and unplug all peripheral devices and the AC power cable.

3. Remove the left side cover. For instructions, see “Removing the Left Side Cover”.

4. Remove the front bezel assembly. For instructions, see “Removing the Front Bezel

Assembly”.

5. Remove the EMI shield from the 5.25-in device drive bay (see letter “A” in the

following figure). Move latch to the “unlock” position (see letter “B”).

Figure 36. Removing 5.25-in Drive EMI Shield (DP/WS/BRP configuration shown)

TP01063