Service Guide

Hardware Installations and Upgrades
52 Intel® Server Chassis SC5650-DP/WS/BRP/UP Service Guide
Removing a Hot Swap Power Supply (BRP configuration only)
Warning: Hazardous conditions, power supply: Hazardous voltage, current, and energy levels are
present inside the power supply. There are no user-serviceable parts inside it; servicing of
the power supply should be done only by technically qualified personnel.
1. Observe the safety and ESD precautions listed in Appendix A, “Safety Information”.
2. Remove power cable from defective power supply.
3. Press up on green latch (see letter “A” in the following figure) while pulling on handle
(see letter “B”) to remove hot swap power supply from chassis.
Figure 65. Removing Hot Swap Power Supply Module from Chassis
4. Insert new hot swap power supply module.