Technical Product Specification

Hot-swap Hard Disk Drive Bays Intel® Server Chassis SC5600
Revision 1.1
Intel order number E39532-004
58
6.1.7 Clock Generation and Distribution
The 4HDD and 6HDD SAS/SATA HSBP provides one clock source. A 4-MHz crystal provides
clock to the VSC410* controller.
6.1.8 7-Pin SAS/SATA Host Connectors
The 4HDD and 6HDD passive SAS/SATA HSBP provides four or six 7-pin SAS/SATA
connectors that are connected to the host interface of the server board or HBA using a mated
cable.
The following table defines the pin-out of the 7-pin SAS/SATA host connector.
Table 46. 7-pin SAS/SATA Connector Pin-out
Connector Contact Number Signal Name
S1 GND
S2 SATA_DRVnA_RX_P
S3 SATA_DRVnA_RX_N
S4 GND
S5 SATA_DRVnA_TX_N
S6 SATA_DRVnA_TX_P
S7 GND
Note: n=0, 1, 2, 3, 4, 5
6.1.9 IPMB Header - IPMB
The following table defines the pin-out of the 4-pin IPMB Header. This connector is white in
color.
Table 47. IPMB Header Pin-out
Pin Signal Name Description
1 SMB_5VSTB_IPMB_DAT Data
2 GND GND
3 SMB_5VSTB_ IPMB_CLK Clock
4 SMB_5VSTB_ IPMB_ADDR
IPMI interface address selection. Primary (Low)= 0xC0,
Secondary (High) = 0xC2