Installation Guide

Install 2.5” Hard Drive into the Bracket
NOTE
The 2.5” hard drive can be a SSD or SAS and SATA. Refer to your server board
or system documentation to determine SSD/SAS/SATA support for your server
system.
1. Install the 2.5” Hard Drive into bracket from top to align with the 4 screw holes on bracket
Figure 3. Installing 2.5” HDD into the bracket
2. Secure the screws on the right and left side of the bracket(4 M3 screws)
Figure 4. Securing screws on the bracket
2.5" Hard Drive Carrier Kit Installation Guide for Intel
®
Server Chassis/System 3