Install Guide

Installation Information
20 Slimline USB Floppy/CD-ROM/DVD-ROM Drive Kit Install Guide
Re-install Bezel Assembly
1. Remove filler panel from the bezel assembly that corresponds with the position of the
installed slimline drive assembly.
Figure 23. Removing Filler Panel from Bezel Assembly of Intel® Entry Server Chassis
SC5299-E
2. Line up the three clips on the right side of the bezel assembly with the corresponding
slots on the right side of the chassis (see letter “A” in the following figure).
3. Engage the clips with the slots (see letter “B”).
4. Rotate the left side of the bezel assembly towards the chassis (see letter “C”).
5. Snap the two bezel tabs into the corresponding recesses at the left edge of the chassis
front panel (see letter “D”).
Figure 24. Re-installing Bezel Assembly on Intel
® Entry Server Chassis SC5299-E
TP01723
TP02035
D
D
A
A
A
C
A
B