Install Guide

Installation Information

14 Slimline USB Floppy/CD-ROM/DVD-ROM Drive Kit Install Guide

Re-install Bezel Assembly

Note: Both the outer bezel door and inner bezel door are used when the chassis is configured for

the pedestal position. For rack-configured systems, only the inner bezel door is used.

1. For a pedestal-configured system, open the outer bezel door of the bezel assembly

(see letter “A” in the following figure).

2. For both pedestal- and rack-configured systems, remove the filler panel from the inner

bezel door that corresponds to the installed slimline drive assembly.

3. For pedestal-configured systems, close the outer bezel door (see letter “B”).

4. Fit the right edge of the bezel assembly against the right side of chassis and engage

plastic bezel hooks (see letter “C”) into raised metal slots at chassis edge.

Caution: Do not attach bezel assembly to chassis at more than a 40-degree angle

or you will damage the bezel hooks on the right side of the bezel

assembly.

5. Rotate bezel assembly toward chassis and latch the two plastic tabs (see letter “D”) on

left side of bezel assembly to chassis.

Figure 15. Re-installing Bezel Assembly on Intel

® Server Chassis SC5400

Max

AF000606

Max