Install Guide

Installation Information
Slimline USB Floppy/CD-ROM/DVD-ROM Drive Kit Install Guide 11
Remove Bezel Assembly
The bezel assembly consists of two parts, an inner bezel door and an outer bezel door.
Both parts comprise the bezel assembly in the pedestal configuration. In the rack
configuration, only the inner bezel door is used.
To remove the bezel assembly:
1. Release the two plastic tabs (see letter “A” in the following figure) on the left side of
the bezel assembly to disengage the tabs.
2. Rotate the bezel assembly (see letter “B”) no more than 40 degrees outward.
3. At a 40-degree angle, push the bezel assembly away from the chassis (see letter “C”).
4. If the bezel assembly does not immediately disconnect from the chassis, tap the left-
hand side of the bezel assembly to disengage the bezel hooks on the right-hand side of
the chassis.
Caution: Do not rotate the bezel assembly more than 40 degrees or you will damage the bezel hooks
on the right-hand side of the bezel assembly.
Figure 10. Removing Bezel Assembly from Intel® Server Chassis SC5400
AF000610
A
A
B
C
A
A
C
B