Installation Guide

Before You Begin
Six-drive SATA Drive Cage (Expander) Upgrade Kit (AXX6DVR3GEXP)
1
Item Quantity
Drive cage assembly 1
SAS/SATA hot swap drive carriers (pre-installed in drive cage) 6
SAS connection ID label 1
SAS cable assembly 1
IPMB cable 1
This manual 1
Tools and Supplies Needed
• Phillips
*
(cross head) screwdriver (#2 bit)
• Flat-head screwdriver
• Anti-static wrist strap (recommended)
• Needle-nosed pliers
• Serial ATA RAID card (dependent on installation)
• SAS RAID card (dependent on installation)
How to Use this Guide
If you are installing drive cage upgrade kits into an Intel® Server Chassis SC5400, SC5400 Base
Redundant Power (BRP) or SC5400 LX follow the instructions under the section titled “
Intel®
Server Chassis SC5400 Installation
.”
For either chassis, if you are installing hot swap drives, follow the instructions under the section
titled “
Install Hot Swap Hard Drives”.
For the Intel® Server Chassis SC5400, if you are installing fixed drives, follow the instructions
under the section titled “
Install Fixed Hard Drives.”