Technical Product Specification

Intel® Local Control Panel TPS Supported IPMI Commands
Revision 1.2
Intel order number C96442-003
15
6. Supported IPMI Commands
This section specifies the IPMB commands received by the Intel
®
Local Control Panel. The
requests and responses for supported IPMI commands are also included if they vary from the
IPMI standard request/response data. The Intelligent Platform Management Interface
Specification 2.0 describes overall command format as well as further command details.
When sending requests to the Intel
®
Local Control Panel via the IPMB, set reserved bits to „0‟
unless otherwise noted. Reserved bit fields in responses should be ignored. It should not be
assumed that reserved bits will be returned as a particular fixed value, or that they will always
return the same value. Only unique data is described in this section to avoid conflicts with other
documents.
An X in the table represents command access. The following acronyms denote the operating
modes of the Intel
®
Local Control Panel:
 OPM: Operational Mode
 FTM: Firmware Transfer Mode
Table 1. Intel
®
Local Control Panel Controller IPMB Commands
ID
Command
NetFn
Request Data
Response Data
OPM
FTM
Default
10h
Get FRU Inventory Area Info
Storage
(0A)
FRU ID = 00h
Note 1
X
11h
Read FRU Inventory Data**
Storage
(0A)
FRU ID = 00h
Note 1
Note 1
X
12h
Write FRU Inventory Data**
Storage
(0A)
FRU ID = 00h
Note 1
Note 1
X
Note:
1. Defined in the Intelligent Platform Management Interface Specification.
6.1 Global Commands
Global commands are defined in the Intelligent Platform Management Interface Specification
2.0. The supported commands are listed below.
Table 2. Global Command Summary
ID
Command
NetFn
Request Data
Response Data
OPM
FTM
Default
01h
Get Device ID
App(6)
-
X
X
IPM: Event Generator,
FRU Inventory, Sensor
02h
Cold Reset
App(6)
-
Note 1
X
03h
Warm Reset
App(6)
-
Note 1
X
Note:
1. Defined in the Intelligent Platform Management Interface Specification.