User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Technical Reference
Intel® Server Chassis SC5300 User Guide 59
4. Technical Reference
Power Supply Specifications
600-W Single Power Supply Input Voltages
600-W Power Supply
100-127 V∼ at 50/60 Hz; 10 A max.
200-240 V∼ at 50/60 Hz; 5 A max.
600-W Single Power Supply Output Voltages
600-W Power Supply
The table below lists the total wattage available from the power subsystem for each voltage. If you
configure your system heavily, ensure that your loads do not exceed the combined total wattage of
600 Watts. For information about calculating the power usage for your configuration, see page 64.
Table 4. 600-W Power Supply System Output Capability
Voltage Maximum Current
+3.3 V 20 A
+5.0 V 24 A
+5 V Standby 2 A
+12.0 43 A
–12.0 V 0.5 A
CAUTION
Do not exceed a combined power output of 140 Watts for the +5 V and +3.3 V
outputs. Exceeding a combined 140 Watts will overload the power subsystem
and may cause the power supplies to overheat and malfunction.
The expansion slots on the server board are rated for no more than 25 Watts for any one slot. The
average current usage per slot should not exceed 13 Watts.