User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Maintaining Your Server
Intel® Server Chassis SC5300 User Guide 45
4. Remove the eight screws holding the Fixed Power Supply shield in place (letter “A”). Remove
the two screws holding the Fixed Power Supply inside the power supply bay (letter “B”).
Remove the Fixed Power Supply (letter “C”).
A
C
B
TP00694
Figure 52. Removing Fixed Power Supply
5. Insert new Fixed Power Supply.
6. Secure Fixed Power Supply inside power supply bay with two screws.
7. Secure Fixed Power Supply shield to chassis with eight screws.
8. Route the P1, P2 and P14 cables to the server board.
9. Connect the power cables to the server board, Refer to the Intel® Server Board Quick Start
User’s Guide or User Guide for appropriate power connections.
10. Replace Primary Access Cover (see “Install Primary Access Cover” in Chapter 2 for step-by-
step instructions).
11. Connect power to the Fixed Power Supply.