User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Setting Up the Chassis
Intel® Server Chassis SC5300 User Guide 33
Install Air Ducts
1. If your system has two processors, remove the inner plastic air baffle from the inside of the
Processor Air Duct.
✏
NOTE
This step only applies to systems with two processors. If your server board
has only one processor installed, leave the inner air baffle in place and
proceed to Step 2.
TP00545
Figure 40. Removing Inner Plastic Air Baffle from Processor Air Duct
2. If you are installing an Intel® Server Board SE7320SP2 or SE7525GP2, remove the outer plastic
air baffle.
✏
NOTE
Leave the outer air baffle in place if you are installing an Intel® Server
Board SE7520BD2 or SE7520AF2.
TP00700
Figure 41. Removing Outer Plastic Air Baffle from Processor Air Duct