User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Setting Up the Chassis
Intel® Server Chassis SC5300 User Guide 27
Install Server Board
See your Intel® Server Board Quick Start User’s Guide for server board installation instructions and
installation of the back panel I/O shield. Use the mounting screws, bumpers and standoffs (if
necessary) that came with your chassis to secure the server board to the chassis. Make sure the server
board is properly seated and then tighten the screws firmly, starting with the screws at the center of
the server board.
Install Air Dam
✏ NOTE
This step only applies if an Intel® Server Board SE73020SP2 or Intel® Server Board SE7525GP2
is to be installed in the chassis.
1. Remove adhesive strip from back of Air Dam.
TP00547
Figure 33. Removing Adhesive from Air Dam
2. Place Air Dam into position (as shown in the following figure) with adhesive side making
contact with chassis. Press down firmly on Air Dam to secure it in chassis.
TP00549
Figure 34. Installing Air Dam