User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Setting Up the Chassis
Intel® Server Chassis SC5300 User Guide 23
5. Attach the device slides to the hard drive. This is a tool-less operation. Insert tabs on device
slides into mounting holes on hard drive and then press firmly to secure device slides to hard
drive. Ensure that the metal tabs on the device slides are facing the front of the hard drive and
facing towards each other.
TP00921
Figure 23. Installing Device Slides to Hard Drive
6. Insert drive/slide assembly into drive cage. Make sure that the cable connector end of the hard
drive faces towards the rear of the drive cage. The top of the drive is in the same orientation as
the arrow in the following illustration.
TP00923
Figure 24. Inserting Drive/Slide Assembly into Drive Cage
7. Repeat steps 4-5 for installation of additional hard drives into drive cage.