User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Setting Up the Chassis
Intel® Server Chassis SC5300 User Guide 21
Install Fixed Hard Drive(s)
1. Push the blue plastic release mechanism upward to release the Fixed drive cage (letter “A”).
Pull out the drive cage so that it is partially exposed (about 2 inches out) from the drive bay slot
in the chassis (letter “B”). Partially exposing the drive cage will make it easier to open the
upper door of the drive cage.
A
B
TP00906
Figure 19. Removing Six-drive Fixed Drive Cage from Chassis
✏
NOTE
As an alternative, you may also fully remove the drive cage from its drive bay slot in the
chassis. Take care, however, to position the drive cage horizontally before opening the
drive cage doors or the drive rails will spill out.
2. Loosen the captive screw (letter “A”). Open the upper door (letter “B”).
B
A
TP00919
Figure 20. Unlocking and Opening Upper Drive Cage Door