User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Setting Up the Chassis
18 Intel® Server Chassis SC5300 User Guide
3. Route SCSI/SATA data cables through the chassis openings located near the bottom of the
drive cage. Connect data cables to the respective fixed drive and to the appropriate
connector on the server board.
TP00552
To 4-Drive
Cage
To 6-Drive
Cage
4/6-Drive
Bay Cables
Upper
Bay Cables
Figure 14. Routing SCSI/SATA Data Cables
Install 3.5-inch Floppy Drive
1. Press pair of slides inward (letter “A”) to release and pull slide/filler panel assembly out of
upper device bay. Remove EMI panel from bracket (letter “B”).
TP00535
A
A
B
Figure 15. Removing Slide/Filler Panel Assembly from Upper Device Bay
2. Use a flat blade screwdriver to remove the knock-out insert from the front of tray.