User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Chassis Description
8 Intel® Server Chassis SC5300 User Guide
Chassis Side View
TP00533
Figure 7. Intel® Server Chassis SC5300 Side View
Peripherals
5.25-in Half-height Peripheral Bays
Note: One multi-purpose 5.25-in drive carrier is included with the chassis. This drive carrier can
hold either a floppy drive (by removing the knock-out) or a fixed drive.
The upper bays of the server chassis are designed for removable media peripherals. Three 5.25-in,
half-height drive bays are available for floppy, CD-ROM or tape drives.
Standard and Optional Hot Swap Drive Bays
One bay supporting six cabled drives respectively ships with the standard chassis. Optional hot
swap drive bays may replace the six fixed drive bays. An optional four-drive fixed drive bay (for
cabled drives) is available. No tools are required to replace the fixed drive bays.
Optional four- and six-drive SCSI and six-drive SATA hot swap drive bays are available.