User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
Chassis Description
Intel® Server Chassis SC5300 User Guide 3
Chassis Front View SC5300 LX with Hot Swap Components
TP00557
A
B
L
C
D
E
F
G
H
I
J
K
A. Hot Swap Power Supply/Second Hot Swap Power Supply (accessory)
B. PCI Add-in Card Panel
C. Processor Air Duct
D. PCI Air Duct
E. Hot Swap Fans – Large (2)
F. Hot Swap Fans – Small (2)
G. Hard Drive Cage Release Mechanisms (2)
H. 5.25-inch Device Bays (3)
I. Front Panel USB/Serial B
J. Hot Swap Drive Cage – 4-Drive (accessory)
K. Hot Swap Drive Cage – 6-Drive
L. Rear Serial-B Connector (optional)
Figure 3. Intel® Server Chassis SC5300 LX Front View