User's Guide
Table Of Contents
- About this Manual
- Manual Organization
- Intel® Serverboard Compatibility
- Additional Information and Software
- Safety Information
- Warnings
- Chassis Description
- Setting Up the Chassis
- Tools and Supplies Needed
- Installation Safety Instructions
- Remove Primary Access Cover
- Remove Bezel Assembly
- Remove Air Ducts
- Remove Hot Swap Fans
- Route Power and Data Cables to the Fixed Drives
- Install 3.5-inch Floppy Drive
- Install DVD or CD-ROM Drive.
- Install Fixed Hard Drive(s)
- Install Hot Swap Drive(s)
- Install Hot Swap Fans
- Install Server Board
- Install Air Dam
- Connect Cables to Server Board
- Install Add-in Board(s)
- Install Air Ducts
- Install an Additional Hot Swap Power Supply Module
- Install Bezel Assembly (Pedestal Only)
- Install Primary Access Cover
- Maintaining Your Server
- Tools and Supplies Needed
- Safety: Before You Remove the Access Cover(s)
- Warnings and Cautions
- Replacing a Fixed Fan (For Base and BRP Chassis Only)
- Replacing a Hot Swap Fan
- Replacing the Front Panel Board
- Replacing a Fixed Power Supply
- Replacing a Hot Swap Power Supply
- Replacing a Power Distribution Board
- Upgrading from a Fixed Power Supply to a Hot Swap Power Supply
- Technical Reference
- Equipment Log and Worksheets
- Regulatory and Compliance Information
- Getting Help
- Warranty
ii Intel® Server Chassis SC5300 User Guide
Disclaimer
Information in this document is provided in connection with Intel
®
products. No license, express or implied, by estoppel or
otherwise, to any intellectual property rights is granted by this document. Except as provided in Intel’s Terms and Conditions
of Sale for such products, Intel assumes no liability whatsoever, and Intel disclaims any express or implied warranty, relating
to sale and/or use of Intel products including liability or warranties relating to fitness for a particular purpose, merchantability,
or infringement of any patent, copyright or other intellectual property right. Intel products are not designed, intended or
authorized for use in any medical, life saving, or life sustaining applications or for any other application in which the failure of
the Intel product could create a situation where personal injury or death may occur. Intel may make changes to
specifications and product descriptions at any time, without notice.
Designers must not rely on the absence or characteristics of any features or instructions marked “reserved” or “undefined.”
Intel reserves these for future definition and shall have no responsibility whatsoever for conflicts or incompatibilities arising
from future changes to them. This document contains information on products in the design phase of development. Do not
finalize a design with this information. Revised information will be published when the product is available. Verify with your
local sales office that you have the latest datasheet before finalizing a design.
Intel server boards contain a number of high-density VLSI and power delivery components that need adequate airflow for
cooling. Intel’s own chassis are designed and tested to meet the intended thermal requirements of these components when
the fully integrated system is used together. It is the responsibility of the system integrator that chooses not to use Intel
developed server building blocks to consult vendor datasheets and operating parameters to determine the amount of airflow
required for their specific application and environmental conditions. Intel Corporation can not be held responsible if
components fail or the server board does not operate correctly when used outside any of their published operating or non-
operating limits.
Intel, Intel Pentium, and Intel Xeon are trademarks or registered trademarks of Intel Corporation or its subsidiaries in the
United States and other countries.
* Other names and brands may be claimed as the property of others.
Copyright © 2004-2005, Intel Corporation. All Rights Reserved.