Specification Update

Monthly Specification Update Enterprise Platforms and Services Marketing
5
Errata
1. System will hang while accessing RAID BIOS setup screen with RAID
Midplane in hardware mode installed
Problem On a system with the RAID midplane installed and with the I-button attached,
the system will hang trying to enter the RAID BIOS menu (CTL+G).
Implication A user will not be able to configure RAID settings for a hardware RAID
configuration with the I-button installed on the RAID midplane.
Status This issue was resolved in BIOS revision R0033.
Workaround None
Tracker 189511
2. Mixed PCI Express* (PCIe*) devices installed on the ASR26XXFHLPR
riser full-height slots 1 and 2 may cause a system hang
Problem Adding mixed PCIe* devices (that is, NIC and RAID) in full-height slots 1 and 2
or the two low-profile slots of the ASR26XXFHLPR riser may result in a system
hang while scanning for devices. This problem has only been seen with a few
select pairings of cards.
Implication Users may not be able to mix PCIe* devices in full-height slots 1 and 2 or the
two low-profile slots of the ASR26XXFHLPR riser.
Status This issue may be resolved in a future BIOS revision.
Workaround Place similar cards in slots 1 and 2 of the riser.
Tracker 189508
3. Cannot boot to SATA CD-ROM device with SATA SW RAID enabled in
conjunction with a 1064e backplane installed
Problem If a 1064e midplane is installed in the system and SATA SW RAID is enabled
in the BIOS setup, the system hangs when accessing a SATA CD-ROM device.
Implication Enabling SATA SW RAID with a 1064e backplane installed is not a supported
configuration and will result in a system hang if trying to boot from a SATA CD-
ROM device.