Service Guide

Intel
®
Server System SR2612UR Service Guide 41
10. Using the SATA cable supplied with the drive, route the cable from each disk drive
to the CPU server board SATA connectors.
Figure 32. Connections Diagram
11. Carefully reinstall the CPU server board air duct.
12. Reinstall the top cover and tighten the captive screw.
13. Reinstall the power cord(s).
DVD Installation
The Intel
®
Server System SR2612UR supports an optional DVD. Complete the following
steps to install a DVD drive in the Intel® Server System SR2612UR.
1. Ensure the AC power cord(s) are disconnected from the enclosure.
2. Remove the top cover from the enclosure by loosening the captive screw with a
Phillips screwdriver on the right rear of the enclosure.
3. Slide the top cover back and lift it from the enclosure.
4. On the rear of the enclosure, locate the removable DVD cover plate.
5. Remove the four screws and cover plate using a Phillips* screwdriver shown in the
following figure.