Service Guide

Intel
®
Server System SR2612UR Service Guide 87
Audible Alarm
There is an audible alarm for fault conditions on both the RAID controller and the dual
power supplies. For RAID controller error conditions, please refer to the manufacturer's
documentation. The power supply alarm sounds if a power supply has failed or is not
properly seated.
Note: You can also use the LSI MegaRaid software supplied with the RAID controller to manage
and monitor the system configuration. LSI MegaRaid is a trademark of LSI Corporation.
2 Disk Status Green/Amber
3 Disk Activity Green
Table 7. LED Status (SAS/SATA) for the Disk Drive
LED Flash Pattern Indication
2 Repeating cycle of Green for 250 milliseconds/
Off for 250 milliseconds
Identify
Amber On constantly Fault
Repeating cycle of Amber for 250 milliseconds/
Off for 250 milliseconds
Predicted Fail
Repeating cycle of Amber for 500 milliseconds/
Green for 500 milliseconds
Reserved Device
Repeating cycle of Amber for 500 milliseconds/
Green for 500 milliseconds (Green on
constantly with Midplane firmware 105 or later)
Hot Spare
Repeating cycle of Amber for 500 milliseconds/
Green for 500 milliseconds
Consistency Check
Repeating cycle of Amber for 500 milliseconds/
Green for 500 milliseconds
In Critical Array
Repeating cycle of Amber for 500 milliseconds/
Green for 500 milliseconds
In Failed Array
Repeating cycle of Green for 750 milliseconds/
Off for 250 milliseconds
Rebuild
Repeating cycle of Green for 500 milliseconds/
Off for 500 milliseconds
Prepare for Operation
Repeating cycle of Green for 500 milliseconds/
Off for 500 milliseconds
Prepare for Removal
Table 6. LED Status for the Disk Drive
LED Condition Color