Technical Product Specification

Peripheral and Hard Drive Subsystem Intel® Server System SR2625UR TPS
Intel order number E46130-010 Revision 1.8
60
6.3 Optional Tape Drive or Additional Hard Drives Flex Bay
For system configurations that require either a Tape Drive or two additional fixed 2.5-inch drives,
a multi-purpose drive bay is provided. By default, this drive bay is covered by one face plate.
The bay is located next to the control panel.
Figure 31. Flex Bay
To configure two additional fixed 2.5-inch hard drives, a drive cage is installed in the default
filler panel (Product Order Code – ASR2600FIXDRV). The kit includes one cage supporting two
fixed 2.5-inch drives, four vibration isolators, power and SAS/SATA cables, and all
required hardware.
Note: These 2.5-inch drives are not hot-swappable and must be cabled to either the server
board or an add-in controller card.
To install a 3.5-inch tape drive, the filler panel is removed and the optional tape drive kit is
installed (Product Order Codes – ASR2500SATAPE or ADRTAPEKIT). Both tape drive kits
include tape drive mounting tray and necessary cables.
Note: To remove the tape drive tray from the system, a spring latch located inside the system
on the back right side of the carrier must be released to allow the drive tray to slide free. Do not
attempt to pull out the drive tray without first releasing the spring latch. Doing so may damage
the plastic faceplate.
Figure 32. Optional Tape Drive (Front View)