Service Guide

62 Intel
®
Server System SR1625UR Service Guide
Installing and Removing a Slimline Optical Drive
Cautions: The slimline optical drive is NOT hot-swappable. Before removing or replacing the drive,
you must first take the server out of service, turn off all peripheral devices connected to
the system, turn off the system by pressing the power button, and unplug the AC power
cord from the system or wall outlet.
To maintain proper system cooling, a filler blank must be installed if you do not install a
device at this location.
Installing a Slimline Optical Drive
To install the slimline optical drive, follow these steps:
1. Install the plastic guide onto the rear of the optical drive and attach with two screws
as shown in Figure 48.
Figure 48. Installing the Plastic Guide to the Optical Drive
2. Insert the optical drive tray assembly into the server system opening and push all
the way until it stops (see Figure 49).
3. Make sure that the back end of the device plugs into the matching socket on the
backplane.
TP02233