Service Guide

Intel
®
Server System SR1625UR Service Guide 41
2. Push the bezel onto the front of the server system until it clicks into place.
Figure 24. Installing the Front Bezel
Removing and Installing the System Cover
Removing the Server System Cover
The server system must be operated with the chassis cover in place to ensure proper
cooling. You will need to remove the top cover to add or replace components inside of the
server.
Note: A nonskid surface or a stop behind the server system may be needed to prevent the server
system from sliding on your work surface.
To remove the server system cover, follow these steps:
1. Remove the security screw if it is installed (see letter "A" in Figure 25).
2. While holding in the blue button at the top of the server system in (see letter "B" in
Figure 25), slide the top cover back until it stops (see letter "C" in Figure 25).
3. Insert your finger in the notch (see letter “D” in Figure 25) and lift the cover
upward to remove it.
AF002846