Service Guide

Intel
®
Server System SR1600UR Service Guide 81
Removing the Backplane Board
To remove the backplane board, follow these steps:
1. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser
Assembly” on page 41.
2. Remove the processor air duct. For instructions, see “Removing the Processor Air
Duct” on page 46.
3. Disconnect all cables from the backplane board.
4. Remove the bridge board by opening the retention clips from the backplane and the
server board (see letter “A” in Figure 72), and lifting straight up (see letter “B” in
Figure 72)
.
Figure 72. Removing the Bridge Board from the Server System
5. Loosen the thumbscrew on the backplane board (see letter “A” in Figure 73).
6. Hold the backplane board only by the edges and slide the backplane board in the
direction shown to release it (see letter “B” in Figure 73).
Server
Board
A
AF002903
A
B