Service Guide

46 Intel

Server System SR1600UR Service Guide

Figure 31. Removing a Full-height Add-In Card

Note: Make sure that the empty add-in card slot has the filler panel installed.

4. Install the PCI riser assembly into the server system. For instructions, see

“Installing the PCI Riser Assembly” on page 42.

Removing and Installing the Processor Air Duct

Always operate your server server system with the processor air duct in place. The air duct

is required for proper airflow within the server system.

For instructions on adding or replacing a processor, first remove the processor air duct,

and then see your server board user guide for instructions on processor installations and

removals. Return to these instructions to reinstall the processor air duct after installing

your processor and heatsink.

Removing the Processor Air Duct

To remove the processor air duct, follow these steps:

1. Remove the PCI riser assembly. For instructions, see “Removing the PCI Riser

Assembly” on page 41.

2. Lift the processor air duct from its location over the two processor sockets.

Riser Connector

AF002854